Installation Procedure
- Remove the caps from the brake caliper and the brake hose.
- NOTE:
The brake hose must not be twisted. Make sure the brake hose is not in contact with any suspension component.
Rear Brake Hose (1) - Install
- Rear Brake Hose Fitting Gasket (3) - Install NEW [2x]
- Rear Brake Hose Fitting Bolt (2) @ Rear Brake Hose (1) - Install and tighten42 N.m (31 lb ft)
- Remove the caps or plugs from the brake pipe fitting and the brake hose.
Rear Brake Pipe Clip (1) @ Rear Brake Hose (2) - Install
- NOTE:
Use a backup wrench at the rear brake hose when tightening the rear brake pipe fitting.
Rear Brake Pipe Fitting (1) @ Rear Brake Hose (2) - Install and tighten25 N.m (18 lb ft)
- Bleed the brake system. Hydraulic Brake System Bleeding (Pressure) , or Hydraulic Brake System Bleeding (Manual)
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation (Without Dual Rear Wheels) , or Tire and Wheel Removal and Installation (With Dual Rear Wheels)
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution .
NOTE:
Ensure that the brake hose does not make contact with any part of the suspension or the tire/wheel assembly. If the brake hose makes contact remove the brake hose and correct the condition.