Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Power Brake Booster Fluid Flow Alarm Switch (1) @ Power Steering Pump Inlet Hose - Install
Courtesy of GENERAL MOTORS COMPANY

Using the J 22610 (2) Install a NEW clamp and tighten. (1) [4x]
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Electrical Connector - Install (3)
Hex Nut - Install and tighten (2) 1.3 N.m (11.5 lb in)
Protective Cap - Install (1)
Fill and bleed the power steering system. Power Steering System Bleeding