Installation Procedure
- NOTE:
The brake hose must not be twisted. Make sure the brake hose is not in contact with any suspension component.
Front Brake Hose (3) - Install
- Front Brake Hose Bolt (2) @ Front Brake Hose (3) - Install and tighten [2x] 10 N.m (89 lb in)
- Front Wheel Speed Sensor (1) @ Front Brake Hose (3) - Install
- Remove the caps from the brake caliper and the brake hose.
Front Brake Hose Fitting Gasket (3) - Install NEW [2x]
- Front Brake Hose Fitting Bolt (2) @ Front Brake Hose (1) - Install and tighten44 N.m (32 lb ft)
- Remove the caps or plugs from the brake pipe fitting and the brake hose.
Front Brake Pipe Clip (1) @ Front Brake Hose (2) - Install
- NOTE:
Use a backup wrench at the front brake hose when tightening the front brake pipe fitting.
Front Brake Pipe Fitting (1) @ Front Brake Hose (2) - Install and tighten25 N.m (18 lb ft)
- Bleed the brake system. Hydraulic Brake System Bleeding (Pressure) , or Hydraulic Brake System Bleeding (Manual)
- Install the front tire and wheel assembly. Tire and Wheel Removal and Installation (Without Dual Rear Wheels) , or Tire and Wheel Removal and Installation (With Dual Rear Wheels)
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution .
NOTE:
Ensure that the brake hose does not make contact with any part of the suspension or the tire/wheel assembly. Inspect the brake hose in extreme right and left turn conditions. If the brake hose makes contact remove the brake hose and correct the condition.