Installation Procedure
Brake Pedal (1) - Install
- CAUTION:
Refer to Fastener Caution .
Brake Pedal Bolt (1) @ Brake Pedal (2) - Install and tighten33 N.m (24 lb ft)
Power Brake Booster Nut (1) - Install and tighten [4x] - Power Brake Booster Replacement
- Lubricant @ Brake Pedal Pivot Pin - Apply - Adhesives, Fluids, Lubricants, and Sealers
Brake Pedal Push Rod (3) - Connect
- Brake Pedal Push Rod Retainer (2) - Install
- Brake Pedal Push Rod Retainer Bolt (1) - Install and tighten - Power Brake Booster Replacement
- Clip the wiring harness to the brake pedal.
Brake Pedal Position Sensor (1) - Install - Brake Pedal Position Sensor Replacement
- Calibrate the brake pedal position sensor. Brake Pedal Position Sensor Calibration
NOTE:
Ensure that the brake pedal push rod retainer is fully engaged in the groove of the brake pedal pivot pin.