Installation Procedure
- Lubricate the brake master cylinder reservoir seals with GM approved brake fluid from a clean, sealed, brake fluid container.
Brake Master Cylinder Reservoir Seal (3) - Install NEW [2x]
- Brake Master Cylinder Reservoir (2) - Install
- Brake Master Cylinder Reservoir Retainer (1) - Install and tighten [2x] 8 N.m (71 lb in)
- Electrical Connector @ Brake Fluid Level Indicator Switch - Connect
- Fill the brake master cylinder reservoir to the maximum-full level with GM approved brake fluid from a clean, sealed brake fluid container. Brake Master Cylinder Reservoir Filling .
CAUTION:
Refer to Fastener Caution .