Disc Brake Component Specifications

Application	Specification
Application	Metric	English
Front Brake JH6
Rotor Discard Thickness *	36.50 mm	1.437 in
Rotor Minimum Allowable Thickness After Refinish	37.0 mm	1.457 in
Rotor Thickness New	38.0 mm	1.496 in
Rotor Maximum Allowable Lateral Runout	0.13 mm	0.005 in
Rotor Maximum Allowable Scoring	1.50 mm	0.059 in
Rotor Maximum Allowable Thickness Variation	0.025 mm	0.001 in
Front Brake JH9
Rotor Discard Thickness *	36.50 mm	1.437 in
Rotor Minimum Allowable Thickness After Refinish	37.0 mm	1.457 in
Rotor Thickness New	38.0 mm	1.496 in
Rotor Maximum Allowable Lateral Runout	0.13 mm	0.005 in
Rotor Maximum Allowable Scoring	1.50 mm	0.059 in
Rotor Maximum Allowable Thickness Variation	0.025 mm	0.001 in
NOTE: GM does NOT recommend any resurfacing of the park brake portion of the rear brake rotor. If light sanding will not remove the surface imperfections (rust/corrosion/pitting), the rotor should be replaced. Rear Brake JH6
Rotor Discard Thickness *	27.50 mm	1.083 in
Rotor Minimum Allowable Thickness After Refinish	28.0 mm	1.102 in
Rotor Thickness New	29.0 mm	1.142 in
Rotor Maximum Allowable Lateral Runout	0.13 mm	0.005 in
Rotor Maximum Allowable Scoring	1.50 mm	0.059 in
Rotor Maximum Allowable Thickness Variation	0.025 mm	0.001 in
NOTE: GM does NOT recommend any resurfacing of the park brake portion of the rear brake rotor. If light sanding will not remove the surface imperfections (rust/corrosion/pitting), the rotor should be replaced. Rear Brake JH9
Rotor Discard Thickness *	38.5 mm	1.516 in
Rotor Minimum Allowable Thickness After Refinish	39.0 mm	1.535 in
Rotor Thickness New	40.0 mm	1.575 in
Rotor Maximum Allowable Lateral Runout	0.13 mm	0.005 in
Rotor Maximum Allowable Scoring	1.50 mm	0.059 in
Rotor Maximum Allowable Thickness Variation	0.025 mm	0.001 in
* All brake rotors have a discard dimension cast into them. Replace any rotor that does not meet this specification. After refinishing the rotor, replace any rotor that does not meet the minimum thickness specifications.