Removal Procedure
WARNING:
Refer to Brake Dust Warning .
- Disable the parking brake cable adjuster. Parking Brake Cable Adjuster Disabling
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation (Without Dual Rear Wheels) , or Tire and Wheel Removal and Installation (With Dual Rear Wheels)
Parking Brake Rear Cable (2) @ Rear Parking Brake Actuator Lever (1) - Remove - Parking Brake Rear Cable Replacement - Left Side , or Parking Brake Rear Cable Replacement - Right Side
- NOTE:
Do not separate the brake rotor from the wheel hub.
Rear Brake Rotor and Hub Assembly (1) - Remove - Rear Axle Hub, Bearing, Cup, and/or Seal Replacement
Rear Parking Brake Shoe (1) - Remove [2x] - Parking Brake Shoe Replacement (JH6) , or Parking Brake Shoe Replacement (JH9)
Rear Parking Brake Actuator Lever (1) @ Rear Brake Shield (2) - Remove
Rear Brake Shield Bolt (2) - Remove [3x]
- Rear Brake Shield (1) - Remove
Rear Parking Brake Actuator Boot (2) @ Rear Brake Shield (1) - Remove