Assembly Procedure

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution .

Rear Brake Caliper Bleeder Valve (2) - Install and tighten - Hydraulic Brake System Bleeding (Pressure) , or Hydraulic Brake System Bleeding (Manual)
Rear Brake Bleeder Valve Cap (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Apply a thin coat of brake fluid from a clean, sealed brake fluid container to the brake caliper piston boot. (1) Adhesives, Fluids, Lubricants, and Sealers
Rear Brake Caliper Piston Seal (2) - Install [2x]
Rear Brake Caliper Piston Boot (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Install the rear brake caliper pistons (1) into the rear brake caliper housing.

Use firm, downward hand pressure to press the brake caliper pistons squarely into the caliper bores.
Seat the edge of the brake caliper dust seals in the groove in the brake caliper piston.
If necessary, carefully lift the edge of the brake caliper dust seals at the brake caliper piston to release any trapped air.
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Caliper (1) @ Rear Brake Caliper Guide Pin - Install

Ensure the rear brake caliper guide pin seals are fully seated in the groove of the rear brake caliper bracket.
Courtesy of GENERAL MOTORS COMPANY

Rear Disc Brake Pad Retainer Spring (1) - Install [4x]
Courtesy of GENERAL MOTORS COMPANY

Rear Disc Brake Inner Pad (1) - Install
Rear Disc Brake Outer Pad (2) - Install
Courtesy of GENERAL MOTORS COMPANY

Install the rear brake caliper and bracket assembly (1). Rear Brake Caliper Replacement (JH6) , or Rear Brake Caliper Replacement (JH9)