Installation Procedure

Apply a light coat of high temperature silicone brake lubricant to the brake caliper guide pin surfaces. Adhesives, Fluids, Lubricants, and Sealers
- Apply lubricant to the brake caliper guide pin shafts.
- Apply lubricant to the brake caliper guide pin seats.
- Apply lubricant to the brake caliper guide pin threads.
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Caliper Guide Pin Bushing (1) - Install
Apply a light coat of high temperature silicone brake lubricant to the brake caliper guide pins and guide pin bores.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Rear Brake Caliper Guide Pin- Upper (1) - Install and tighten61 N.m (45 lb ft)
Rear Brake Caliper Guide Pin- Lower (2) - Install and tighten61 N.m (45 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Caliper Guide Pin Seal (2) - Install [2x] - Rear Disc Brake Mounting and Hardware Inspection (With Single Rear Wheel) , or Rear Disc Brake Mounting and Hardware Inspection (With Dual Rear Wheel)

Ensure the rear brake caliper guide pin seals are fully seated in the groove of the rear brake caliper housing.
Rear Brake Caliper Guide Pin Boot (1) - Install [2x] - Rear Disc Brake Mounting and Hardware Inspection (With Single Rear Wheel) , or Rear Disc Brake Mounting and Hardware Inspection (With Dual Rear Wheel)
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do not remove the brake caliper guide pins unless replacement is required.

Rear Brake Caliper Bracket (1) @ Rear Brake Caliper - Install

Ensure the brake caliper guide pin seals are fully seated in the grooves of the brake caliper bracket.
Courtesy of GENERAL MOTORS COMPANY

Rear Disc Brake Pad Retainer Spring (1) - Install [4x]
Courtesy of GENERAL MOTORS COMPANY

Rear Disc Brake Outer Pad (2) - Install
Rear Disc Brake Inner Pad (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Install the rear brake caliper and bracket assembly (1). Rear Brake Caliper Replacement (JH6) , or Rear Brake Caliper Replacement (JH9)