Up and Down Adjustment
- Remove the sliding side door upper roller cover. Refer to Rear Side Door Upper Roller Bracket Garnish Molding Replacement .
- Remove the sliding side door lower roller cover.
Loosen the bolts that retain the upper front roller to the door.
Loosen the bolts that retain the lower front roller to the door.
- Loosen the nuts that retain the rear roller to the door.
- Adjust the door up or down until you obtain the desired position.
- Tighten the nuts that retain the rear roller to the door to 25 N.m (18 lb ft).
Tighten the bolts that retain the upper front roller to the door to 25 N.m (18 lb ft).
Tighten the bolts that retain the lower front roller to the door to 25 N.m (18 lb ft).
- Install the sliding side door lower roller cover.
- Install the sliding side door upper roller cover. Refer to Rear Side Door Upper Roller Bracket Garnish Molding Replacement .
CAUTION:
Refer to Fastener Caution .