Removal Procedure
- Prepare the brake system control module for removal with Service Programming System (SPS) and follow the on-screen instructions.
Front Compartment Rear Access Cover (2) - Remove - Front Compartment Rear Access Cover Replacement
Battery Tray (1) - Remove - Battery Tray Replacement
- Electrical Connector @ Brake Fluid Level Sensor - Disconnect
- Electrical Connector @ Brake System Control Module - Disconnect
- NOTE:
Label the brake pipes to ensure they are re-installed in the correct ports of the brake pressure modulator valve.
Front and Rear Brake Front Pipe Nut (1) - Remove [4x]
- Cap the front and rear brake front pipes to prevent brake fluid loss and contamination.
- Plug the brake pressure modulator valve inlet ports to prevent brake fluid loss and contamination.
Front Brake Pipe Fitting Bolt (1) - Remove
- Front Brake Pipe Bracket (2) - Reposition
Electronic Brake Control Module Bolt (1) - Remove [4x]
- Brake System Control Module (2) - Remove
CAUTION:
When removing the Brake System Control Module (BSCM) from the Master Cylinder Assembly, ensure the valve coils in the (BSCM) clear the pins in the Master Cylinder Assembly. If the coils or pins are damaged the complete Master Cylinder Assembly will require replacement.