LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Corvette 2D Convertible >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Diagnostic Information and Procedures >> DTC C1052 >> Component Testing

Component Testing

  1. Ignition OFF, disconnect the harness connector at the S86 Vehicle Stability Control System Switch.
  2. Test for infinite resistance between terminal 3 and the ground terminal 6 with the switch in the open position.
    • If less than infinite resistance 

      Replace the S86 Vehicle Stability Control System Switch.

    • Go to next step: If infinite resistance 
  3. Test for less than 5 Ω between terminal 3 and the ground terminal 6 with the switch in the closed position.
    • If 5 Ω or greater 

      Replace the S86 Vehicle Stability Control System Switch.

    • Go to next step: If less than 5 Ω 
  4. All OK.
scientia non olet · About LEMON Manuals