Floor Panel Tunnel Panel Reinforcement Replacement

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Lifting and Jacking the Vehicle
1	Floor Panel Tunnel Panel Reinforcement Bolt @ Mid Tunnel [6x] CAUTION: Refer to Fastener Caution Tighten 22 N.m (16 lb ft)
2	Rear Cradle Brace Bolt [2x] Procedure Loosen the rear cradle brace bolts. Tighten 160 N.m (118 lb ft)
3	Floor Panel Tunnel Panel Reinforcement Procedure Remove the 6 floor panel tunnel panel reinforcement bolts (1). Slide the floor panel tunnel panel reinforcement rearward, into the opening.