LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 10L60 (Mi1), 10L80 (Mi2) Or 10L90 (Mi4) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Transmission Fluid Drain and Fill >> Installation Procedure

Installation Procedure

  1. Fig 1: Exploded View Of Transmission Fluid Pan, Bolts, Filter And Gasket Components
    GM4540404Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The fluid pan gasket is reusable. Inspect the gasket to determine if it may be reused. If the gasket is stuck to the case or pan, it should be replaced.

    Install the automatic transmission fluid pan gasket (3) to the fluid pan.

  2. Install the automatic transmission fluid pan (2) to the transmission.
  3. Fig 2: Identifying Automatic Transmission Fluid Pan Bolts With Tightening Sequence
    GM4540558Courtesy of GENERAL MOTORS COMPANY

    Install the automatic transmission fluid pan bolts (1) and tighten in the sequence shown to 10 N.m (89 lb in).

  4. Fill the transmission. Transmission Fluid Level and Condition Check
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals