LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 10L60 (Mi1), 10L80 (Mi2) Or 10L90 (Mi4) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Propeller Shaft Transmission Flange Replacement >> Installation Procedure

Installation Procedure

  1. GM4539081Courtesy of GENERAL MOTORS COMPANY

    Install the propeller shaft transmission flange (2) to the output shaft.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the NEW propeller shaft transmission flange nut (1) and tighten to 105 N.m (77 lb ft).
  3. GM4011641Courtesy of GENERAL MOTORS COMPANY

    Remove the J-45012  Holding Fixture (3) from the propeller shaft transmission flange (2).

    4. CAUTION:

    Stake the flange nut onto the output shaft. Use the two staking grooves on the shaft to locate the staking points. Failure to stake the flange nut may result in damage to the transmission.

  4. Stake the propeller shaft transmission flange nut (1).
  5. Install the propeller shaft. Two-Piece Propeller Shaft Replacement (Coupe with M5T, MI1, MI2, MI4) , or Two-Piece Propeller Shaft Replacement (Convertible with M5T, MI1, MI2, MI4)
scientia non olet · About LEMON Manuals