LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 10L60 (Mi1), 10L80 (Mi2) Or 10L90 (Mi4) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Automatic Transmission Manual Shift Shaft Position Switch Replacement >> Installation Procedure

Installation Procedure

  1. GM4540962Courtesy of GENERAL MOTORS COMPANY

    Connect the park pawl actuator rod (2) to the automatic transmission manual shift shaft position switch (3).

  2. Install the automatic transmission manual shift shaft position switch (3) to the transmission.
  3. GM4540965Courtesy of GENERAL MOTORS COMPANY

    Install the manual shift shaft (2) aligning the position switch assembly onto the shaft.

  4. GM4540962Courtesy of GENERAL MOTORS COMPANY

    Install the NEW manual shift shaft pin (1).

  5. Install the control valve body. Control Valve Body Replacement 
  6. Connect the automatic transmission range selector lever cable to the transmission. Automatic Transmission Range Selector Lever Cable Replacement 
scientia non olet · About LEMON Manuals