LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 10L60 (Mi1), 10L80 (Mi2) Or 10L90 (Mi4) - Repair Instructions - Off Vehicle >> Repair Instructions - Off Vehicle >> Case Extension Assembly Installation

Case Extension Assembly Installation

  1. Fig 1: Exploded View Of Case Extension Assembly Components With Tightening Sequence
    GM4481899Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Case Extension Seal (1) - Install NEW

  2. Grease the inner part of the output shaft seal where the output shaft rides before installing the extension onto the transmission. Adhesives, Fluids, Lubricants, and Sealers
    3. CAUTION:

    Before installing the transmission case extension to the transmission case, make certain all internal transmission components including the stator shaft support assembly and output carrier are in place. Failure to do so may result in damage to the transmission.

  3. Automatic Transmission Case Extension (2) - Install
  4. Automatic Transmission Case Extension Bolt (3) - Install and hand tighten [6x]
    5. CAUTION:

    Refer to Fastener Caution .

  5. Automatic Transmission Case Extension Bolt (3) - Tighten in
    1. First Pass: 20 N.m (15 lb ft)
    2. Final Pass: 58 N.m (43 lb ft)
scientia non olet · About LEMON Manuals