LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Valve Stem Oil Seal and Valve Spring Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4166267Courtesy of GENERAL MOTORS COMPANY

    Use the EN-46116  remover/installer (1) in order to install the valve stem seal (2).

  2. GM4166266Courtesy of GENERAL MOTORS COMPANY

    Valve Spring (2) - Install

  3. Valve Spring Retainer (1) - Install
  4. GM4166262Courtesy of GENERAL MOTORS COMPANY

    Install the EN-46335-A  compressor (1) above the applicable cylinder as shown.

  5. Tighten the EN-46335-A  compressor bolt (2).
  6. Install the valve spring keepers (3).
  7. EN-46335-A  compressor - Remove
  8. Disconnect the EN-39313  adapter from the compressed air source.
  9. EN-39313  adapter - Remove
  10. Spark Plug - Install - Spark Plug Replacement
  11. Install the rocker arms. Valve Rocker Arm Replacement - Right Side 
  12. GM4117498Courtesy of GENERAL MOTORS COMPANY

    EN-46106  tool (1) - Remove

  13. Install the starter. Starter Replacement (LGX) .
scientia non olet · About LEMON Manuals