LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Valve Stem Oil Seal and Valve Spring Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the valve rocker arms. Valve Rocker Arm Replacement - Left Side 
  2. Remove the starter. Starter Replacement (LGX) .
  3. GM4117498Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    If the EN-46106  tool is not installed, the crankshaft may rotate. If the crankshaft rotates, disassembly and reassembly of the entire camshaft timing system may be required.

    Install the EN-46106  tool (1) in order to prevent crankshaft rotation.

  4. Remove the spark plug from the applicable cylinder. Spark Plug Replacement
  5. Install the EN-39313  adapter to the applicable cylinder.
  6. Connect the EN-39313  adapter to a compressed air source.
  7. GM4166262Courtesy of GENERAL MOTORS COMPANY

    Install the EN-46335-A  compressor (1) above the applicable cylinder as shown.

  8. Tighten the EN-46335-A  compressor bolt (2).
  9. Remove the valve keepers (3).
  10. Loosen the EN-46335-A  compressor bolt and remove the compressor.
  11. GM4166266Courtesy of GENERAL MOTORS COMPANY

    Valve Spring Retainer (1) - Remove

  12. Valve Spring (2) - Remove
  13. GM4166267Courtesy of GENERAL MOTORS COMPANY

    Use the EN-46116  remover/installer (1) in order to remove the valve stem seal (2).

scientia non olet · About LEMON Manuals