Intake Manifold Installation
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | Intake Manifold |
| 2 | Intake Manifold Bolt [8x]
CAUTION:
Refer to Fastener Caution . Tighten in sequence 25 N.m (18 lb ft) |
| 3 | Positive Crankcase Ventilation Tube Connector |
| 4 | Engine Rear Noise Shield
WARNING:
The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death. |
| 5 | Fuel Pipe Shield |
| 6 | Fuel Pipe Shield Bolt Tighten 10 N.m (89 lb in) |
| 7 | Fuel Pipe Shield Bolt [2x] Tighten 10 N.m (89 lb in) |