Intake Manifold Assemble

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Intake Manifold Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Intake Manifold Seal NOTE: Install a NEW seal.
2	Manifold Absolute Pressure Sensor
3	Manifold Absolute Pressure Sensor Bolt CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Do not use paints, lubricants, or corrosion inhibitors on fasteners, or fastener joint surfaces, unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems. When using fasteners that are threaded directly into plastic, use extreme care not to strip the mating plastic part (s). Use hand tools only, and do not use any kind of impact or power tools. Fastener should be hand tightened, fully seated, and not stripped. Tighten 4 N.m (35 lb in)
4	Evaporative Emission Canister Purge Solenoid Valve Tighten 10 N.m (89 lb in)
5	Throttle Body Gasket NOTE: Install a NEW gasket.
6	Throttle Body
7	Throttle Body Bolt [4x] Tighten 10 N.m (89 lb in)
8	Intake Manifold Insulator
9	Intake Manifold Insulator Retainer [4x]