Engine Mount Bracket Replacement - Left Side

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Drivetrain and Front Suspension Cradle Replacement (LGX - Coupe) , or Drivetrain and Front Suspension Cradle Replacement (LGX - Convertible) Detach wire harness retainer at engine mount.
1	Engine Mount Bracket Fastener (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 58 N.m (43 lb ft)
2	Engine Mount Bracket NOTE: Engine mount brackets are magnesium. To prevent galvanic corrosion, the bracket includes pressed on spacers on the back side. Even though it is highly unlikely, the pressed on spacers may loosen and fall off during engine mount bracket removal. Ensure the spacers are in place before reinstalling an existing bracket.

Callout

Component Name

Preliminary Procedures

Drivetrain and Front Suspension Cradle Replacement (LGX - Coupe) , or Drivetrain and Front Suspension Cradle Replacement (LGX - Convertible)
Detach wire harness retainer at engine mount.

Engine Mount Bracket Fastener (Qty: 3)

CAUTION:

Refer to Fastener Caution .

Tighten
58 N.m (43 lb ft)

Engine Mount Bracket

NOTE:

Engine mount brackets are magnesium. To prevent galvanic corrosion, the bracket includes pressed on spacers on the back side. Even though it is highly unlikely, the pressed on spacers may loosen and fall off during engine mount bracket removal. Ensure the spacers are in place before reinstalling an existing bracket.