Front Cover Removal

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Camshaft Position Actuator Control Valve and Belt Idler Pulley Removal

Callout	Component Name
1	Electrical Connector NOTE: The retaining clips attached to the oil pump flow control solenoid wire are used for initial production only and should be removed and discarded. The oil pump flow control solenoid may be different depending on model.
2	Engine Front Cover CAUTION: Do not pry against the face of the camshaft position actuators or the position actuator retaining bolts as the position actuators will be damaged. Procedure Locate pry points to aid in loosening the cover.
3	Engine Front Cover Locating Pin [2x]