LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Clutch Assembly - Remove - Clutch Assembly Replacement (M13 Transmission) , or Clutch Assembly Replacement (MJK, MH3, MM6)
  2. GM4017622Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Note the position and direction of the engine flywheel before removal. The flywheel does not use a locating pin for alignment. Mark or scribe the end of the crankshaft and the flywheel before component removal. The existing manual transmission engine flywheel must be installed to the original position and direction.

    Mark or scribe the end of the crankshaft and the manual transmission flywheel.

  3. GM4017620Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Install the EN-46106  Flywheel Holding Tool and bolts.

  4. GM4017624Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT reuse the flywheel bolts.

    Remove and DISCARD the flywheel bolts (2).

  5. Remove the manual transmission flywheel (1).
  6. Note the location of the manual transmission flywheel balance weights, if applicable.
  7. Remove the EN-46106  Flywheel Holding Tool.
scientia non olet · About LEMON Manuals