Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Camshaft Timing Chain-Right Side - Remove - Camshaft Timing Chain Assembly Replacement - Right Side
Fuel Injection Fuel Rail Noise Shield (1) - Remove - Fuel Injection Fuel Rail Noise Shield Replacement
Warm Up Three-Way Catalytic Converter (3) @Bank 1 - Remove - Warm Up Three-Way Catalytic Converter Replacement (LH - LGX) , or Warm Up Three-Way Catalytic Converter Replacement (RH - LGX)
- Fuel Pump - Remove - Fuel Pump Replacement
- Remove the ground wire bolt and ground wire.
- Disconnect and reposition harness as necessary.
- Camshaft-Right Side - Remove - Camshaft Removal - Right Side
Camshaft Carrier - Right Side (2) - Remove - Camshaft Carrier Removal - Right Side
Valve Lifter-Right Side - Remove - Valve Lifter Replacement - Right Side
Cylinder Head Bolt (1) [8x] - Remove and DISCARD
- Remove and DISCARD the rear M8 right cylinder head bolt (2).
- Cylinder Head Assembly (3) - Remove
- Cylinder Head Gasket (4) - Remove and DISCARD
- Cylinder Head - Clean and inspect - Cylinder Head Cleaning and Inspection
- Engine Block - Clean and inspect - Engine Block Cleaning and Inspection
- Disassemble the cylinder head as necessary. Cylinder Head Disassemble