Cylinder Head Removal - Right Side
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | Cylinder Head Bolt M11 x 178 [8x] Procedure Remove and DISCARD the bolts. |
| 2 | Cylinder Head Bolt M8 x 80.8 Procedure Remove and DISCARD the bolts. |
| 3 | Cylinder Head |
| 4 | Cylinder Head Gasket Procedure Remove and DISCARD the cylinder head gasket. |
| 5 | Fuel Injection Fuel Rail Noise Shield
WARNING:
The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death. |