Removal Procedure
WARNING: This page is about a different variant/trim than selected.
Drive Belt (1) - Remove - Drive Belt Replacement
Front Compartment Lower Noise Shield (4) - Remove - Front Compartment Lower Noise Shield Replacement (Coupe - LGX, LTG)
Install the EN-52287 Balancer Holding Kit (1) and the EN-956 - 1 Extension Bar (2) to the crankshaft balancer (3).
Crankshaft Balancer Bolt (1) - Remove and DISCARD
- Remove the EN-52287 Balancer Holding Kit and the EN-956 - 1 Extension Bar.
Install the EN-41816 - A Crankshaft Balancer Remover (1) with the EN-44226 - 5 Crankshaft Protector (2), and use tool adjustment to release the crankshaft balancer (3).
- Once the crankshaft balancer (2) has released, remove the EN-41816 - A Crankshaft Balancer Remover (1) and the EN-44226 - 5 Crankshaft Protector.
Crankshaft Balancer (1) - Remove
- Crankshaft Balancer (1) - Clean and inspect