Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Install a 5/8 inch washer (2) onto the EN-38836 Pilot Bushing Installer/Clutch or equivalent. The washer serves as a stop against the crankshaft face and will assist in installing the bearing to the proper depth.
- Install the new pilot bearing (1) onto the tool.
Install a new pilot bearing into the crankshaft using the EN-38836 Pilot Bushing Installer/Clutch.
- Inspect the clutch pilot bearing for proper installation. A properly installed clutch pilot bearing will be installed until flush to the rear of the crankshaft.