LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Camshaft Timing Chain Components Installation >> Right Timing Chain Guide and Timing Chain Tensioner Installation

Right Timing Chain Guide and Timing Chain Tensioner Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Exploded View Of Right Timing Chain Guide And Timing Chain Tensioner Assembly Components
GM3979324Courtesy of GENERAL MOTORS COMPANY
Right Timing Chain Guide and Timing Chain Tensioner Installation

Callout Component Name
1 Timing Chain Guide- Right Side
2 Timing Chain Guide Bolt
Tighten 
25 N.m (18 lb ft)
3 Timing Chain Tensioner Gasket
NOTE:

Ensure the right timing chain tensioner mounting surface on the right cylinder head does not have any burrs or defects that would degrade the sealing of the NEW right timing chain tensioner gasket.

4 Timing Chain Tensioner- Right Side
WARNING:

The timing chain tensioner plunger is under high tension and must be retained by using the tensioner retraction pin during removal or installation of the timing chain tensioner. Failure to retain the timing chain tensioner plunger may cause it to be ejected with intense force and cause personal injury.

Procedure

  1. Reset the timing chain tensioner plunger using your thumb and EN-52234  Timing Chain Tensioner Retaining Pin or a 1/8" drill bit to retain the plunger.
  2. Compress the plunger into the body and lock the right timing chain tensioner by inserting EN-52234  Timing Chain Tensioner Retaining Pin or 1/8" drill bit into the access hole in the side of the right timing chain tensioner body.
  3. Slowly release pressure on the right timing chain tensioner. The right timing chain tensioner should remain compressed.

Special Tools 
EN-52234  Timing Chain Tensioner Retaining Pin
Equivalent regional tools: Special Tools
5 Timing Chain Tensioner Bolt

Procedure

  1. Place the chain tensioner into position and loosely install the bolts to the block.
  2. Tighten the timing chain tensioner bolts.
  3. Verify the timing marks are in the correct position before releasing the drive chain tensioner.
  4. Release the timing chain tensioner plunger by pulling out the suitable tool.
  5. Verify the left timing chain timing mark alignments by referring to Timing Chain Alignment Diagram - Stage Two.

Tighten 
25 N.m (18 lb ft)