LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Camshaft Installation - Left Side >> Camshaft Bearing Cap Sequence

Camshaft Bearing Cap Sequence

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Camshaft Bearing Cap Bolts With Tightening Sequence - Left Side
GM5518232Courtesy of GENERAL MOTORS COMPANY
Camshaft Bearing Cap Sequence

Callout Component Name
1 Camshaft Bearing Cap Bolt
CAUTION:

Refer to Fastener Caution .

Tighten in sequence

  1. First Pass: 6 N.m (53 lb in)
  2. Final Pass: 45 degrees
2 Camshaft Carrier Bolt [4x]

Tighten in sequence

  1. First Pass: 6 N.m (53 lb in)
  2. Final Pass: 45 degrees
3 Camshaft Bearing Cap Bolt [12x]

Tighten in sequence

  1. First Pass: 6 N.m (53 lb in)
  2. Final Pass: 60 degrees
scientia non olet · About LEMON Manuals