Manifold Absolute Pressure Sensor Replacement
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Intake Manifold Cover Replacement |
|
| 1 | Manifold Absolute Pressure Sensor Fastener
CAUTION:
Refer to Fastener Caution . Tighten: 10 N.m (89 lb in) |
| 2 | Manifold Absolute Pressure Sensor Procedure Electrical Connector @ Manifold Absolute Pressure Sensor - Disconnect
NOTE:
Always install the seal supplied with the manifold absolute pressure sensor. |