Camshaft Position Actuator Valve Solenoid Replacement - Bank 2 (Left Side) Intake
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Intake Manifold Cover Replacement |
|
| 1 | Electrical Connector |
| 2 | Camshaft Position Actuator Solenoid Valve Bolt
CAUTION:
Refer to Fastener Caution . Tighten 10 N.m (89 lb in) |
| 3 | Camshaft Position Actuator Solenoid Valve |
| 4 | O-Ring
NOTE:
Install a NEW O-ring seal.
NOTE:
Lubricate the NEW O-ring seals with clean engine oil. |
| 5 | Camshaft Position Actuator Solenoid Valve Seal
NOTE:
Always install the camshaft position actuator solenoid valve seal supplied with the NEW camshaft position actuator solenoid valve. If reinstalling the valve, inspect the camshaft position actuator solenoid valve seal and replace as necessary. |