LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls And Fuel - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Locating Pin Control Valve Replacement (Bank 2) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Air Cleaner Outlet Duct Replacement  - Remove
  2. GM4143526Courtesy of GENERAL MOTORS COMPANY

    Retainer (1) - Remove [2x]

  3. Engine Wiring Harness (2) - Reposition
  4. GM4143693Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (1) - Disconnect

  5. Camshaft Position Actuator Locating Pin Control Valve Bolt (2) - Remove
  6. Camshaft Position Actuator Locating Pin Control Valve (3) - Remove
  7. Camshaft Position Actuator Solenoid Valve Seal (4) - Inspect the seal, remove and DISCARD as necessary. - Engine Front Cover Disassemble