Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON.

NOTE:

A low battery voltage or charging system condition may cause a DTC to set.

Verify DTC P0121, P0122, P0123, P0222, P0223, P0562, P0621, P0622, or P2135 is not set.
- If any of the DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- Go to next step: If none of the DTCs are set
Verify the scan tool Throttle Body Idle Air flow Compensation parameter is less than 90 %.
- If 90 % or greater
  Refer to Throttle Body Inspection and Cleaning .
- Go to next step: If less than 90 %
Clear the DTCs with a scan tool.
Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down.
Ignition ON.
Verify the scan tool TAC Motor parameter displays Enabled while slowly depressing the accelerator pedal.
- If Enabled is Not displayed
  Refer to Circuit/System Testing.
- Go to next step: If Enabled is displayed
Verify DTC P1516, P2101, P2119, or P2176 is not set.
- If any of the DTCs are set
  Refer to Circuit/System Testing.
- Go to next step: If none of the DTCs are set

NOTE:

If there is a condition with the throttle body, the TAC Motor Command parameter will go to 99 % for a predetermined amount of time and then a DTC sets. Once a DTC is set, the TAC Motor Command parameter will go to 0 % and the TAC Motor parameter will display Disabled.

Verify the scan tool TAC Motor parameter displays Enabled while performing the Throttle Sweep Test with a scan tool.
- If Enabled is Not displayed
  Replace the Q38 Throttle Body assembly.
- Go to next step: If Enabled is displayed
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing.
- Go to next step: If the DTC does not set
All OK