LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 3.6L (LGX) - Diagnostic Information And Procedures (P0443 - P3400) And Symptoms) >> Diagnostic Information and Procedures >> DTC P129D >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

For an overview of the component/system, refer to: Fuel System Description

Component Description
K20 Engine Control Module The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly.
K111 Fuel Pump Driver Control Module The control module K111 supplies the fuel pump with a PWM signal in order to achieve the desired fuel line pressure.

When the ignition is turned On, the ECM sends a 12 V signal to the control module K111 to enable the fuel pump. If the engine is not started, the control module K111 turns the fuel pump Off after 6 s.

scientia non olet · About LEMON Manuals