Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the electrical connector: Q17 Fuel Injector
- Test for 1 to 3 ohms between the test points: Control circuit terminal 2 & Control circuit terminal 1
- If not between 1 and 3 ohms
Replace the component: Q17 Fuel Injector
- Go to next step: If between 1 and 3 ohms
- If not between 1 and 3 ohms
- Test for infinite resistance between the test points: Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component: Q17 Fuel Injector
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.
NOTE:
The specified resistances are valid for components at room temperature.