Assembling Components
WARNING: This page is about a different variant/trim than selected.
- Assemble components using only the sealant, or equivalent, that is specified in the service procedure.
- Sealing surfaces must be clean and free of debris or oil.
- Specific components such as crankshaft oil seals or valve stem oil seals may require lubrication during assembly.
- Components requiring lubrication will be identified in the service procedure.
- Apply only the amount of sealant specified in the service procedure to a component.
- Do not allow the sealant to enter into any blind threaded holes, as the sealant may prevent the fastener from clamping properly or cause component damage when tightened.
- Tighten the fasteners to the proper specifications.
NOTE:
Do not overtighten the fasteners.