LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (Automatic Transmission - 8L45 (M5T) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Transmission Case Front Cover and Drive Link Installation

Transmission Case Front Cover and Drive Link Installation

WARNING: This page is about a different variant/trim than selected.
  1. Fig 1: Exploded View Of Transmission Case Front Cover and Drive Link Components With Tightening Sequence
    GM3977954Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Front Support Cover Gasket (1) - Install NEW

  2. Drive Sprocket Thrust Washer- Rear (2) - Install
  3. Drive Sprocket (3) - Install
  4. Drive Link (4) - Install
  5. Drive Sprocket Thrust Washer- Front (5) - Install
  6. Automatic Transmission Case Front Cover Seal (6) - Install NEW
  7. Ensure the drive link assembly is not pinched by the front cover and moves freely on the drive sprocket.
  8. Automatic Transmission Case Front Cover (7) - Install
  9. CAUTION:

    Refer to Fastener Caution .

  10. Automatic Transmission Case Front Cover Bolt (8) - Install NEW and tighten in sequence M6 x 30 [11x] 9.5 N.m (84 lb in)