Torque Converter Installation and Holding Fixture Removal
WARNING: This page is about a different variant/trim than selected.
Special Tools
- DT-03289-20 Holding Fixture Base Assembly
- DT-48989 Holding Fixture
Equivalent regional tools: Special Tools
Rotate the transmission so that the converter housing is up and secure with locking pin.
- Torque Converter (1) - Install
- After installing the torque converter (1), install a holding strap to secure the torque convertor (1) before rotating back to remove special tools.
- Support the transmission with an overhead hoist attached to DT-48989 Holding Fixture (2).
- Remove the DT-48989 Holding Fixture (2) with the Automatic Transmission Case (3) from the DT-03289-20 Holding Fixture Base Assembly (4)
- Remove the DT-48989 Holding Fixture (2) from the Automatic Transmission Case (3).