Stator Shaft Support Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Stator Shaft Support Components And Bolts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

Align the bolt hole indicated by the arrow with the arrow that is cast into the case and push down to seat.
Stator Shaft Support (1) - Install

CAUTION:

Refer to Fastener Caution .

Stator Shaft Support Bolt (2) - Install and tighten M8x33 [9x] 35 N.m (26 lb ft)
Turbine Shaft Seal - O-Ring (3) - Install NEW