Stator Shaft Support Assemble (8L90)

Special Tools

• DT-50912  Seal Installer

Equivalent regional tools: Special Tools

1. Fig 1: Exploded View Of Stator Shaft Support Components

   Courtesy of GENERAL MOTORS COMPANY
   CAUTION:

   Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage.

   CAUTION:

   Size the fluid seal rings for at least 5 minutes after installation to obtain proper seal ring size. Failure to do so may cause internal transmission leaks and transmission damage.

   NOTE:

   Use the large taper side of DT-50912-1  seal sizer for initial seal sizing, then flip the tool over for final sizing.

   Torque Converter Fluid Seal (1) - Install NEW

NOTE:

Ensure fluid seal ring is installed properly as shown.

2. 1-3-5-6-7 Clutch Fluid Seal Ring (2) - Install NEW [2x]