Single Use Fasteners and Components

• Torque Converter Fluid Seal
• 1-3-5-6-7 Clutch Fluid Seal Ring [2x]

Special Tools

• DT-51196  Seal Installer

Equivalent regional tools: Special Tools

1. Fig 1: Exploded View Of Stator Shaft Support Components

   Courtesy of GENERAL MOTORS COMPANY
   CAUTION:

   Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage.

   CAUTION:

   Size the fluid seal rings for at least 5 minutes after installation to obtain proper seal ring size. Failure to do so may cause internal transmission leaks and transmission damage.

   Use DT-51196-1  Seal Protector (1) and DT-51196-2  Seal Pusher (2) to install Torque Converter Fluid Seal (3).

2. Torque Converter Fluid Seal (3) - Install NEW
3. Use the large taper side of DT-50912-1  Seal Sizer (4) for initial seal sizing, then flip the tool over for final sizing.
NOTE:

Ensure fluid seal ring is installed properly as shown.

4. 1-3-5-6-7 Clutch Fluid Seal Ring (5) - Install NEW [2x]