Single Use Fasteners and Components
WARNING: This page is about a different variant/trim than selected.
- 1-2-3-4-5-Reverse Clutch Piston Dam Retaining Ring
- 1-2-3-4-5-Reverse Clutch Piston Dam Seal
- 1-2-3-4-5-Reverse Clutch Piston Outer Seal
- 1-2-3-4-5-Reverse Clutch Piston Inner Seal
Special Tools
- DT-26941 Bushing and Bearing Remover
- DT-45124 Removal Bridge
- DT-45124-9 Puller Leg
- DT-47693-2 Compressor
- GE-8433 Puller Bar
Equivalent regional tools: Special Tools
-
Courtesy of GENERAL MOTORS COMPANY
Use DT-47693-2 Compressor (1) and an arbor press to remove the 1-2-3-4-5-Reverse Clutch Piston Dam Retaining Ring (2).
- 1-2-3-4-5-Reverse Clutch Piston Dam Retaining Ring (2) - Remove and DISCARD
- 1-2-3-4-5-Reverse Clutch Piston Dam (4) - Remove
- 1-2-3-4-5-Reverse Clutch Piston Dam Seal (3) - Remove and DISCARD
- 1-2-3-4-5-Reverse Clutch Piston Return Spring (4) - Remove
-
Courtesy of GENERAL MOTORS COMPANY
1-2-3-4-5-Reverse Clutch Piston (1) - Remove
- 1-2-3-4-5-Reverse Clutch Piston Outer Seal (2) - Remove and DISCARD
- 1-2-3-4-5-Reverse Clutch Piston Inner Seal - O-Ring (3) - Remove and DISCARD
- 1-2-3-4-5-Reverse Clutch Piston Inner Seal (4) - Remove and DISCARD
Assemble the DT-45124 Removal Bridge (1), DT-45124-9 Puller Leg (2) and DT-26941 Bushing and Bearing Remover (3).
- Ensure the feet of DT-26941 Bushing and Bearing Remover (3) are properly engaged with the Output Shaft Bearing (4).
- Output Shaft Bearing (4) - Remove
Assemble the DT-26941 Bushing and Bearing Remover (3), DT-45124-9 Puller Leg (2) and GE-8433 Puller Bar (1). Use the GE-8433 Puller Bar (1) with threaded rod, nut, washer and bearing from DT-45124 Removal Bridge.
- Ensure the feet of DT-26941 Bushing and Bearing Remover (3) are properly engaged with the Output Shaft Bearing (4).
- Output Shaft Bearing (4) - Remove
Automatic Transmission Case Extension Hole Plug (1) - Remove [2x]
CAUTION:
Refer to Seal Reuse Caution .
CAUTION:
Refer to Seal Reuse Caution .