Case Extension Assemble (8L45)
WARNING: This page is about a different variant/trim than selected.
Special Tools
- DT-47693-2 Compressor Adapter
- DT-51087 Bearing Installer
- GE-8092 Driver Handle
Equivalent regional tools: Special Tools
Automatic Transmission Case Extension Hole Plug (1) - Install and tighten [2x] 11 N.m (97 lb ft)
Assemble the tools as shown. Use the GE-8092 Driver Handle with DT-51087 Bearing Installer.
- Output Shaft Bearing (1) - Install
-
Courtesy of GENERAL MOTORS COMPANY
Assemble the tools as shown. Use the GE-8092 Driver Handle with DT-51087 Bearing Installer.
- Output Shaft Bearing (1) - Install
- 1-2-3-4-5-Reverse Clutch Piston Inner Seal - O-Ring (2) - Install NEW
- 1-2-3-4-5-Reverse Clutch Piston Inner Seal (3) - Install NEW
- 1-2-3-4-5-Reverse Clutch Piston Outer Seal (4) - Install NEW
- 1-2-3-4-5-Reverse Clutch Piston (5) - Install
-
Courtesy of GENERAL MOTORS COMPANY
1-2-3-4-5-Reverse Clutch Piston Return Spring (1) - Install
- 1-2-3-4-5-Reverse Clutch Piston Dam Seal (2) - Install NEW
- 1-2-3-4-5-Reverse Clutch Piston Dam (3) - Install
- Use DT-47693-2 Compressor Adapter and an arbor press to install the retaining ring.
- 1-2-3-4-5-Reverse Clutch Piston Dam Retaining Ring (4) - Install NEW
CAUTION:
Refer to Seal Reuse Caution .
CAUTION:
Refer to Seal Reuse Caution .