Fastener Specifications (On Vehicle)
WARNING: This page is about a different variant/trim than selected.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Manual Shaft Shift Pin |
| Manual Shift Shaft Seal |
| Torque Converter Fluid Seal |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Input Speed Sensor Wiring Harness Bolt | |
|
4 N.m (35 lb in) |
|
45 Degrees |
| Output Speed Sensor Wiring Harness Bolt | |
|
4 N.m (35 lb in) |
|
45 Degrees |
| Torque Converter Bolt | 63 N.m (46 lb ft) |
| Transmission Fluid Baffle Bolt | |
|
4 N.m (35 lb in) |
|
45 Degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Automatic Transmission Auxiliary Fluid Accumulator Bolt | 8 N.m (71 lb in) |
| Automatic Transmission Control Indicator Screw | 2.5 N.m (22 lb in) |
| Auxiliary Heater Pump Bracket to the Transmission Fastener | 10 N.m (89 lb in) |
| Flywheel Inspection Cover/Converter Cover Fastener | 10 N.m (89 lb in) |
| Oil Pressure Test Plug | 11 N.m (97 lb in) |
| Propeller Shaft Transmission Flange Nut | 105 N.m (77 lb ft) |
| Range Selector Lever Cable Bracket Fastener | 22 N.m (16 lb ft) |
| Transmission Control Fastener | 9 N.m (80 lb in) |
| Transmission Fluid Pan Fastener | 10 N.m (89 lb in) |
| Transmission Heat Shield Fastener | 9 N.m (80 lb in) |
| Transmission to Engine Bolt | 58 N.m (43 lb ft) |
| Transmission Range Selector Cable Lever Nut | 30 N.m (22 lb ft) |
| Valve Body Assembly Bolt (1, 2) (1 - M6 x 68) and Bolt (2 - M6 x 45) | 9 N.m (80 lb in) |