LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0010 - P0336)) >> Diagnostic Information and Procedures >> DTC P0182, P0183, P0187, P0188, P0191, P0192, P111F, P126E, P126F, P127C, P128A, P128B, P16E4, or P16E5 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Connect a 3 A fused jumper wire between the test points: 5 V Reference terminal 3 & 5 V@K20 Engine Control Module
  2. Connect a jumper wire between the test points: Low Reference terminal 1 & Ground
  3. Test for 2. 5 to 4. 0 V between the test points: Signal terminal 2 & Low Reference terminal 1
    • If not between 2. 5 and 4. 0 V 

      Replace the component: B310 Fuel Pressure/Temperature Sensor

    • Go to next step: If between 2. 5 and 4. 0 V 
  4. All OK.
scientia non olet · About LEMON Manuals