Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Position the hydraulic clutch hose/pipe in the vehicle.
Seat the grommet (1) into the floor.
Connect the hydraulic clutch hose/pipe (2) to the clutch master cylinder.
- Install the hydraulic clutch hose/pipe retaining clip (1) to the clutch master cylinder.
- Raise the vehicle.
Connect the lower slave cylinder hose (2) to the slave cylinder.
- Install the hydraulic clutch hose/pipe retaining clip (1) to the clutch slave cylinder.
- Bleed the clutch hydraulic system. Hydraulic Clutch System Bleeding
- Lower the vehicle.
- Install the heater and air conditioning evaporator and blower module in the vehicle. Heater and Air Conditioning Evaporator and Blower Module Removal and Installation (LGX)