Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY
NOTE:
- The lower crankcase surface must be free of contamination prior to applying the sealer.
- Install and align the oil pan to block within 20 minutes of applying the sealer.
- The oil pan must be fastened to final torque specification within 60 minutes of applying the sealer.
Apply a 4.25 mm bead of sealer (1) on the level part of the flange around the perimeter of the oil pan. Adhesives, Fluids, Lubricants, and Sealers
Courtesy of GENERAL MOTORS COMPANY

Upper Oil Pan (2) - Install
Upper Oil Pan Bolt (1, 2, 3) - Loosely install [13x]
Fig 1: Identifying Engine Oil Pan Bolts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Tighten in the sequence shown.
1. First Pass: (1-11) 25 N.m (18 lb ft)
2. Final Pass: (12-13) 10 N.m (89 lb in)
Courtesy of GENERAL MOTORS COMPANY

Transmission Bolt (1) - Install and tighten [2x] 58 N.m (43 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Transmission Bolt (1) - Install and tighten 58 N.m (43 lb ft)
Drivetrain and Front Suspension Cradle - Install - Drivetrain and Front Suspension Cradle Removal and Installation (LTG)
Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Cooler Pipe (2) Move into position [2x]
Transmission Fluid Cooler Pipe Nut (1) - Install and tighten [2x] - Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LTG With M5T, Without V03) , or Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LTG With M5T, With V03)
Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Cooler Inlet and Outlet Pipe@Transmission - Install Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LTG With M5T, Without V03) , or Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LTG With M5T, With V03)
Courtesy of GENERAL MOTORS COMPANY

Wiring Harness Retainer (1) - Connect [2x]
Wiring Harness Connector (2) - Connect
Engine Oil Cooler - Install - Engine Oil Cooler Replacement (LTG)
Courtesy of GENERAL MOTORS COMPANY

Catalytic Converter Brace Bracket (2) - Install
Catalytic Converter Brace Bracket Bolt (1) - Install and tighten [2x] 10 N.m (89 lb in)
Engine Front Cover - Install - Engine Front Cover Replacement
Reposition the A/C compressor and install the A/C compressor bolts. Air Conditioning Compressor Replacement (LTG)
Change the engine oil and filter. Engine Oil and Oil Filter Replacement
Front Compartment Lower Noise Shield - Install - Front Compartment Lower Noise Shield Replacement (Coupe - LGX, LTG)