Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Intake Manifold Gasket (1) - Install NEW
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold (2) - Install
Intake Manifold Bolt (1) - Loosely install [5x]
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold Bolt (1) - Loosely install
Fig 1: Identifying Intake Manifold Bolts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Tighten the bolts in the sequence shown.
1. First Pass: 12 N.m (106 lb in)
2. Final Pass: 12 N.m (106 lb in)
Generator - Install - Generator Replacement (LTG - with V18) , or Generator Replacement (LTG - without V18)
Courtesy of GENERAL MOTORS COMPANY

Engine Mount Vacuum Hose Extension (1) @Intake Manifold - Connect - Engine Mount Vacuum Hose Extension Replacement
Lower the vehicle. Lifting and Jacking the Vehicle (Convertible)
Courtesy of GENERAL MOTORS COMPANY

Radiator Inlet Pipe Bolt (2) - Install and tighten - Radiator Inlet Pipe Replacement (LTG)
Throttle Body Assembly - Install - Throttle Body Assembly Replacement
Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connectors (1-4).
Wiring Harness Retainer (3) - Install [2x]
Connect the evaporative emission pipe to the intake manifold retainer (5).
Courtesy of GENERAL MOTORS COMPANY

Radiator Surge Tank (2) - Install - Radiator Surge Tank Replacement (LTG)
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Canister Purge Solenoid Valve (1) - Install - Evaporative Emission Canister Purge Solenoid Valve Replacement
Courtesy of GENERAL MOTORS COMPANY

Fuel Pump Insulator (2) - Install - Fuel Pump Insulator Replacement (Inner) , or Fuel Pump Insulator Replacement (Outer)
Plenum Front Panel - Install - Plenum Front Panel Replacement (LT1 LT4)