Engine Support Fixture

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Intake Manifold Cover Replacement Front Bumper Fascia Center Support Replacement Special Tools EN-51007-1 Main Support Beam EN-51007-3 Radiator Support Beam EN-51007-4 Clamp EN-51007-5 Support Leg, Front EN-51007-6 Hook EN-51007-7 Support Leg, Side EN-36857 Engine Lift Bracket Equivalent regional tools: Special Tools
1	EN-36857 Engine Lift Bracket [2x] CAUTION: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. Procedure Remove and DISCARD ONLY the engine front cover bolt indicated by arrow. Engine Front Cover Replacement Use a grade 10.9 bolt to install EN-36857 engine lift brackets in the locations shown NOTE: The engine front cover bolt indicated by the arrow is a one time use torque to yield bolt. A NEW bolt should be installed if removed.
2	EN-51007-7 Support Leg, Side Procedure NOTE: Ensure that the engine support fixture only contacts the frame in the area indicated by arrows. Do not install on top of fender lip. Install the EN-51007-7 Support Leg, Side to frame as shown.
3	EN-51007-4 Clamp
4	EN-51007-1 Main Support Beam
5	EN-51007-3 Radiator Support Beam
6	EN-51007-5 Support Leg, Front
7	EN-51007-6 Hook